Auto-Attendant For Incoming Analog Calls - ZyXEL Communications X6004 User Manual

Each field is described in the following table.
Table 87 Configure an FXO Trunk
LABEL
Available
Interface
Used Interface
Apply
Cancel

18.2.3 Auto-Attendant for Incoming Analog Calls

Use this screen to select which auto-attendant should be used with this outbound
line group. See
attendant. Click the Auto-Attendant icon in the in the FXO Trunk section of the
Outbound Group configuration screen to view the screen as shown.
Figure 144 AA for FXO Trunks
Each field is described in the following table.
Table 88 AA for FXO Trunks
LABEL
Apply AA
Extension
Number for Fax
X6004 User's Guide
DESCRIPTION
This column displays the FXO ports available on the X6004. Highlight
one of the FXO ports and click the Right icon if you want to add it to
this outbound line group.
This column displays the FXO ports currently configured for this
outbound line group. Highlight one of the FXO ports and click the Left
icon if you want to remove it from the outbound line group.
If you configure more than one interfaces in this outbound line group,
the X6004 check and pick one of them available for an outgoing call.
Click this to save your changes.
Click this to go to the Outbound Line Group screen without saving
your changes.
Chapter 19 on page 291
DESCRIPTION
Select the Auto-Attendant you want to use when calls come in on this
outbound line group.
Select FAX if you want to forward all incoming calls on this outbound
line group to a fax machine located at a specific extension.
Select Extension if you want to directly forward all incoming calls
through this outbound line group to an extension or a hunting group
number.
Select Skill if you want to forward all incoming calls on this outbound
line group to the group of agents associated with this skill name.
This field is only available if you select FAX in the Apply AA field. Type
the extension of the Fax machine you want to forward calls to.
Chapter 18 Outbound Line Group
for information on configuring auto-
265