The Bri Screen - ZyXEL Communications X6004 User Manual

Hide thumbs Also See for X6004:

Table of Contents

Chapter 6 Server

Table 23 Server > FXS (continued)

Dial Interval

Country Code

6.5 The BRI Screen

Use this screen to configure ISDN BRI interface settings on the X6004. Click

Configuration > PBX > Server Configuration > Server > BRI Configuration

to view the screen as shown next.

Note: You have to reboot the X6004 manually to apply changes in the Switch Type,

NT/TE mode, or TEI fields.

Figure 57 Server > BRI Configuration

Each field is described in the following table.

Table 24 Server > BRI Configuration

Configuration

Select the volume level transmitted to the X6004. -6 is the quietest,

and 6 is the loudest.

Enter the number of seconds the X6004 should wait after you stop

dialing numbers (from FXS extensions) before it makes the phone call.

The signals used by telephone companies to indicate a busy line or an

available line differ by country. You must select the country code for the

location of the X6004. The X6004 can then detect whether the FXS line

is in use or available.

Click this to save your changes.

Click this to set every field in this screen to its last-saved value.

Use these fields to specify the ISDN BRI interface which you want to

Specify the X6004 for which you want to configure ISDN BRI settings.

This field is only configurable if you have more than one X6004 working

in a ZyStack.

X6004 User's Guide