Chapter 7 Auto Provision
7.3.6 snom Firmware Upgrade
Use this screen to configure the firmware upgrade URLs for the snom VoIP devices
connected to the X6004. To access this screen, click Configuration > PBX >
Server Configuration > Auto Provision > snom Profile Setup then click the
snom Firmware Upgrade button.
Figure 73 snom Profile Setting > snom Firmware Upgrade
Each field is described in the following table.
Table 38 snom Firmware Upgrade
LABEL
snom Firmware
Upgrade
Product List
URL
Set Firmware
Url
Cancel
164
DESCRIPTION
This list corresponds to the snom products supported by the X6004.
Enter the upgrade URL for the device in question. You can find this URL
and any other upgrade information at the product page on the official
snom website.
Click Set Firmware URL to save the URL(s) entered on this page.
Click Cancel to go back to the snom Profile Setup screen without
saving any changes.
X6004 User's Guide