The Fxo Screen - ZyXEL Communications X6004 User Manual

Chapter 6 Server

6.3 The FXO Screen

Use this screen to configure settings related to the FXO lines configured on the
X6004. To access this screen, click Configuration > PBX > Server
Configuration > Server > FXO.
Figure 55 Server > FXO
Each field is described in the following table.
Table 22 Server > FXO
LABEL
FXO
Configuration
Machine ID
Slot
Port
TX Volume
RX Volume
Busy Detect
132
DESCRIPTION
Use these fields to specify the FXO interface which you want to
configure.
Specify the X6004 for which you want to configure FXO settings. This
field is only configurable if you have more than one X6004 working in a
ZyStack.
Specify which FXO interface card you want to configure. The cards are
identified by the extension card slot they are installed in. Select one of
the slots or select All to make the settings the same for all FXO
interface cards.
Specify the FXO port on the FXO interface card you want to configure.
Select the volume level transmitted from the X6004. -6 is the quietest,
and 6 is the loudest.
Select the volume level transmitted to the X6004. -6 is the quietest,
and 6 is the loudest.
The X6004 listens for a tone to detect if an FXO line has been hung up.
This tone differs by region and it may also differ slightly between
carriers. In some cases the X6004 may mistake background noise for a
busy line signal.
This setting defines the number of busy tones the X6004 needs to
recognize before actually considering the line to be busy.
You should select a low value, if you have a good connection. Select a
higher value, if your FXO connection is of lower quality to avoid false
hang-ups.
X6004 User's Guide