Reset The X6004 To Its Factory Defaults - ZyXEL Communications X6004 User Manual

Make sure the ZyStack X6004 is up and connected to the network. You can make
2
a ping from the X6004 to it through the CLI command mode.
Makes sure that the IP address of the ZyStack interface on the slave server is in
3
the same subnet as the one on the master server.
Make sure that the serial number, WAN and LAN IP addresses you configured in
4
the Configuration > ZyStack > Setting > Add or Edit screen are correct.
Fail to initiate packet capturing in Maintenance > Administration > Diagnostics
> Packet Capture.
The diagnostics are only available for a "debug administrator". You have to use an
account with "debug admin" privilege rank to log into the X6004 first. See
3.8 on page

39.5 Reset the X6004 to Its Factory Defaults

If you reset the X6004, you lose all of the changes you have made. The X6004 re-
loads its default settings, and the password resets to 1234. You have to make all
of your changes again.
You will lose all of your changes when you push the RESET button.
To reset the X6004,
Make sure the PWR LED is on and not blinking.
1
Press and hold the RESET button for five to ten seconds. Release the RESET
2
button when the PWR LED begins to blink. The default settings have been
restored.
If the X6004 restarts automatically, wait for the X6004 to finish restarting, and log
in to the web configurator. The password is "1234".
If the X6004 does not restart automatically, disconnect and reconnect the X6004's
power. Then, follow the directions above again.
X6004 User's Guide
86.
Chapter 39 Troubleshooting
Section
515