ZyXEL Communications X6004 User Manual page 135

Table 24 Server > BRI Configuration (continued)
LABEL
Slot
Port
Switch Type
NT/TE Mode
TEI
Digit Handling
Tx Volume
Rx Volume
Apply
Cancel
X6004 User's Guide
DESCRIPTION
Specify which ISDN BRI interface card you want to configure. The cards
are identified by the extension card slot they are installed in. Select one
of the slots or select All to make the settings the same for all ISDN BRI
interface cards.
Specify the BRI port on the ISDN BRI interface card you want to
configure.
Select a switch type according to your area and the technology your
telephone company uses. Generally, U.S. telephone exchanges use
5ESS switches while Europe uses NET3 and Australia uses AUS
switches.
As of this writing, the X6004 only supports NET3.
Select NT (Network Terminal) or TE (Terminal Equipment) to decide
the X6004's role when connecting to an ISDN device. See
page 127 for more information.
This Terminal Endpoint Identifier is used to uniquely identify each TE
device. Select Dynamic to automatically request an ID when the X6004
is connected to the network. Or select Fixed and enter a number (0-
63) provided from your telephone company.
Note: You must configure the same TEI on the X6004 and its
connected BRI device.
Specify the signalling method the X6004 accepts to receive a callee's
number through a specified BRI port.
En-bloc: The X6004 expects to receive a complete callee's number at
one time.
Overlap: The X6004 expects to receive digits of a callee's number one-
by-one.
Note: If the switch type is "NT", then Digital Handling can select
"Overlap" or "En-bloc".
Note: If the switch type is "TE", then Digital Handling can select
"En-bloc" only.
Select the volume level transmitted from the X6004. -6 is the lowest,
and 6 is the loudest.
Select the volume level transmitted to the X6004. -6 is the lowest, and
6 is the loudest.
Click this to save your changes.
Click this to set every field in this screen to its last-saved value.
Chapter 6 Server
NT/TE on
135