The Fxs Screen - ZyXEL Communications X6004 User Manual

Table 22 Server > FXO (continued)
LABEL
Country Code
Apply
Reset

6.4 The FXS Screen

Use this screen to configure settings for the analog phones connected to the
X6004. To access this screen, click Configuration > PBX > Server
Configuration > Server > FXS.
Figure 56 Server > FXS
Each field is described in the following table.
Table 23 Server > FXS
LABEL
FXS
Configuration
Machine ID
Slot
Port
Tx Volume
X6004 User's Guide
DESCRIPTION
The signals used to indicate a busy line or an available line differ by
country. You must select the country code for the location of the X6004.
The X6004 can then recognize whether the FXO line is in use or
available. Select default to reset the country code value to the factory
defaults.
Click this to save your changes.
Click this to set every field in this screen to its last-saved value.
DESCRIPTION
Use these fields to specify the FXS interface which you want to
configure.
Specify the X6004 for which you want to configure FXS settings. This
field is only configurable if you have more than one X6004 working in a
ZyStack.
Specify which FXS interface card you want to configure. The cards are
identified by the extension card slot they are installed in. Select one of
the slots or select All to make the settings the same for all FXS
interface cards.
Specify the FXS port on the FXS interface card you want to configure.
Select the volume level transmitted from the X6004. -6 is the quietest,
and 6 is the loudest.
Chapter 6 Server
133