Replacing The Fixing Temperature Sensor /3, And Removing And Reinstalling; The Fixing Temperature Sensor /1 And The Thermostat /1 - Konica Minolta CF5001 Service Manual

Konica minolta cf5001 laser mfp service manual

Hide thumbs Also See for CF5001:

Table of Contents

Replacing the fixing temper-

ature sensor /3, and remov-

ing and reinstalling the fixing

temperature sensor /1 and

the thermostat /1

• After installing the fixing temperature sensor

/3, be sure to check that the sensor section is

in touch with the fixing roller. If not, the tem-

perature control may go abnormal or the fix-

ing temperature sensor /3 may detect the low

fixing temperature abnormality.

• Be sure to check that the wiring harness is

not in touch with the fixing roller.

• The thermostat /1 is an essential safety part.

Be sure to follow the cautions and steps

given below when removing and reinstalling.

• After completion of the installation of the

thermostat /1, be sure to check that the wiring

harness is not in touch with the fixing upper

• Be sure to fasten the thermostat /1 after posi-

tioning it properly with a positioning jig

(4969-1885-01). Be sure to apply screws with

screw lock paint. Also be sure to conduct this

adjustment under the pressure-released con-

dition and the temperature low condition of

the fixing roller /U.

A. Periodically replaced parts/cycle

• Fixing temperature sensor /3: Every 2,500,000

CF5001 Field Service Ver.1.0 Sep 2003