Table of Contents
Advertisement
CF5001 Field Service Ver.1.0 Sep 2003
11.2 Installation / Remove of the
Memory Unit (OPTION)
Note: Handling
• Precautions against static electricity.
Keep the memory unit in an antistatic bag
while transporting or storing.
Discharge electricity from your body by
touching somewhere metallic portion before
handling, when working on the place where
static electricity tend to generate such as on a
carpet.
• Do not touch the gilded pins of memory unit
directly with hands. Direct touch may cause
malcontinuity.
• Do not give the mechanical shock to the mem-
ory unit by dropping or bending and so on.
A. Procedure
1. Remove the Platen cover to Main Board unit.
See 1.5 Removing and reinstalling the main
board unit.
2. Pull it out toward you to remove it from the main
body.
Note:
• When pulling out the main board assembly, be
careful that the memory board doesn't touch
the stay.
3. If the HDD-7 is installed, remove it.
4. Memory unit into the memory slots (4 places) of
the Image processing board.
Image processing board (IPB)
5. To mount the memory unit successfully.
a
Insert the memory unit into the memory slot
while being careful to ensure the direction is as
shown in the picture.
b
Fit the slot pins into the holes at both ends of
the memory unit, and then push it down so that
the claws at both ends of the slot secure the
memory unit.
a
b
6. When demounting the memory unit.
a
Release the claws at both ends of the slot.
b
Raise the memory unit gently to remove it.
a
4 places
7. Reinstall the above parts following the removal
steps in reverse.
4969D514aa
1-115
OTHER
4969D515aa
b
a
4969D516aa
Advertisement
Table of Contents
