Table of Contents
Advertisement
C-208 Ver.1.0 Sep 2003
11. In the same manner as Steps 1 to 5, reinstall the
up/down wire /A [1] on the rear side.
12. In the same manner as Steps 17 to 21, reinstall
the up/down wire /A [2] on the rear side.
13. Rotate the up/down drive shaft [1] clockwise as
seen from the rear side to lift the up/down plate
[2] up to its upper most position.
Note:
• Be sure to wind up the up/down wire /A form
inside to outside in each drive pulley.
• The up/down plate [2] comes down by its own
weight if the installation of the assist wire /C
[3] and the assist wire /D [4] have not been
completed. For this reason, be sure to sup-
port the up/down plate [2] by hands until the
installation of Step 23 is completed. (This
work requires two persons.)
14. Insert the assist wire /C [3] into the wire installa-
tion hole [5] provided outside the up/down drive
shaft [1].
Note:
• The up/down drive shaft [1] is provided with 3
wire installation holes each on the front side
and the rear side. However, since the wire
installation holes on the inside and at the mid-
dle have been already used, only the wire
installation hole on the outside can be con-
firmed for this steps.
15. Insert the drive pulley [6] into the up/down drive
shaft [1] so that the notch [7] of the drive pulley
[6] comes to the position into which the assist
wire /C [3] is put.
[3] [4]
[9] [17]
[15]
[8]
[9]
[7]
[3]
[7]
[5]
[6]
[10]
1-155
TRAY UP/DOWN
[2]
[1]
lt2113041
[16]
[17]
[2]
[4]
[14]
[3]
[1]
[13]
[4]
[1]
[18]
[12]
[11]
[1]
lt2113043
Advertisement
Table of Contents
