Table of Contents
Advertisement
PROCESS UNIT
4.12 Replacing the 2nd transfer
roller /U
A. Periodically replaced parts/cycle
• 2nd transfer roller /U: Every 200,000 copies
B. Procedure
1. Remove the transfer belt. (See "4.10 Replacing
the transfer belt.")
2. After raising the 2nd transfer roller /U [1] once,
remove it diagonally from the lower side.
Note:
• The fixing of the 2nd transfer roller /U was
released when the transfer belt was removed
at the time of the removal of the high voltage
supply curler.
• Be sure to reinstall the 2nd transfer roller /U
so that the shaft end with a dent comes to the
bottom.
3. Remove 2 bearings [2] from the 2nd transfer
roller /U [1].
4. Reinstall the above parts following the removal
steps in reverse.
CF5001 Field Service Ver.1.0 Sep 2003
1
2
[2]
1-42
[2]
[1]
[1]
8050ma3056
Advertisement
Table of Contents
