Table of Contents
Advertisement
CF5001 Field Service Ver.1.0 Sep 2003
5. Remove the screw [1] and then remove the knob
[2].
6. Remove the paper exit mounting plate /F [3] and
the paper exit open/close spring /F [4].
7. Remove two screw [5] and then remove the
bearing [6].
8. Remove the E-ring [7] and then remove the
paper exit drive pulley /1 [8] and the pin [9].
9. Remove the E-ring [10] and then remove the
paper exit drive gear /4 [11] and the pin [12].
10. Remove the bearing [13], paper exit mounting
plate /R [14], curler /1 [15] and the paper exit
open/close spring /R [16].
11. Slide the bearing [17] to the inside and remove
the decurler [18].
12. Reinstall the above parts following the removal
steps in reverse.
Note:
• When reinstalling the paper exit drive pulley /1
[8], be sure to take note of the direction of the
belt guide.
• When the decurler roller is replaced, reset "5.
Parts counter" and "1. Count of special
parts." If not, the fixing jam may occur.
REGISTRATION/ADU/REVERSE/PAPER EXIT
[16]
[13]
[12]
[15]
[14]
[11]
[10]
[5]
[6]
[2]
[1]
[3]
1-113
[9]
[17]
[8]
[7]
[5]
[18]
[4]
8050ma3097
Advertisement
Table of Contents
