Table of Contents
Advertisement
PAPER FEED TRAYS /1 to /3
B. Attaching the wire
Note:
• Since the composition of the paper feed trays
/1 to /3 is the same, the explanation here is
made of the steps for the paper feed tray /1.
1. Install the wire /C [3] to the wire holding shaft [2]
with a screw [1] from the bottom side of the
paper feed tray.
2. After winding the wire /C [3] around the pulley
[4], insert it into the shaft [6] together with the
wire restraining cover [5] and fasten it with an E-
ring [7].
3. Install the wire /D [10] to the wire holding shaft
[9] with a screw [8] from the bottom side of the
paper feed tray.
[7]
[6]
[2]
[17]
[5]
[4]
[3]
[1]
1-64
CF5001 Field Service Ver.1.0 Sep 2003
4. After winding the wire /C [3] and the wire /D [10]
around the pulley [11], insert it into the shaft [13]
together with the wire restraining cover [12] and
fasten it with an E-ring [14].
Note:
• Be sure to wind the wires around the pulley
[11] so that the wire /C [3] comes to the out-
side and the wire /D [10] to the inside.
5. After sliding the drive pulley [15] to the outside
with the wire /C [3] and the wire /D [10] inserted
into the up/down drive shaft [14], fasten it with
an E-ring [16].
[12]
[11]
[4]
[13]
[8]
[9]
[16]
[17]
[18]
[3]
[10]
[14]
[15]
8050ma3169
Advertisement
Table of Contents
