CF5001 Field Service Ver.1.0 Sep 2003
3.7
Precautions for use
3.7.1
Prior announcement to administrator
When performing the Internet ISW, be sure to contact the copier's administrator or the like and get his/her
agreement beforehand.
Perform ISW in condition that the copier is not being used.
If the copier is being used (a job is being processed), the Internet ISW is not performed.
3.7.2
If power failure occurs during data rewriting
While ISW rewriting is in progress *17, the operation panel and main switch (SW2) are locked. However, if
the main power goes down due to power failure or other, the copier becomes unable to start up. *18
This is only the problem on rewriting the overall control board and the operation board/1. Even if errors
occur on rewriting other boards, the boards can be overwritten again with the Internet ISW.
If the copier becomes unable to start for the above reason, go to the copier's site and rewrite the program
using the ISWTrns.
<How to recover> Overall control board : Turn ON the main switch (SW2) and then perform ISW.
Operation board /1: Turn ON the main switch (SW2) while pressing HELP and CHECK
button and then perform ISW.
For the details, please refer to "1. ISW"
*
17
Rewriting takes maximum 10 minute.
*
18
No problem is cased by power failure during program downloading process.
3.7.3
ISW of multiple programs
It is not possible with the Internet ISW to ISW several programs concurrently. Always perform ISW one by
one. If several programs must be rewritten at the same time, perform ISW from board of higher priority. *19
Priority 1
RADF control board (F), FNS control board (N)
Priority 2
Printer control board (C), Operationboard/1 (O)
Priority 3
Overall control board (I)
When rewriting several programs, SC may occur during rewriting intervals between programs.
However, such SC will clear when all the subject programs are rewritten.
*
19
In case of the Internet ISW using the E-mail remote notification system, the sequence of transmitted
ISW designating mails and mails received by copier may change. Transmit multiple mails while ensur-
ing reception of completion mail or putting enough intervals.
3.7.4
If ISW fails in low power mode
If ISW fails due to errors in program download, data check, and so on, the copier recovers into normal
mode. Only in low power mode, the copier reboots when ISW fails.
3-41
INTERNET ISW