Xerox Phaser 4620 Service Manual page 68

08-800-00 Jam in Tray 6 RAP
08-800-00 Media remains in the Tray 6 Pick Assembly.
BSD-Reference: WD 14
Initial Actions
1. Check media condition.
2. Check for obstructions in the media path.
3. Check for worn or damaged rollers.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Nudger, Feed, and Separator Rollers for excessive wear or contamination. The
rollers are undamaged and clean.
Y N
Clean or replace the rollers.
Check for obstructions or debris in the media path. The media path is clear.
Y N
Clear the media path of obstructions or debris.
Check Pick Assembly (PL 8.20 Item 17) motion. Pick assembly motion is good.
Y N
Repair improper pick assembly motion.
Select dC330 code 08-650 to test the Take Away Sensor. The sensor signal changes (high/
low).
Y N
Remove the Right Cover (REP 7.25) and reseat CN3 on the Feeder Board, then retest.
The sensor signal changes.
Y N
Replace the sensor, REP 8.44.
Reassemble and perform SCP 6 Final Actions.
Select dC330 code 08-856 to test the Feed Clutch. The clutch is engaged (on/off).
Y N
Remove the Right Cover (REP 7.25) and reseat CN9 on the Feeder Board, then retest.
The clutch is engaged.
Y N
Replace the Feed Clutch, REP
Reassemble and perform SCP 6 Final Actions.
Select dC330 code 08-960 to test the Feed Drive. The Feed Drive Assembly rotates (on/
off).
Status Indicator RAPS
08-800-00
WARNING
8.41.
Y N
Remove the Right Cover (REP
The Feed Drive Assembly rotates.
Y N
Replace the Feed Drive Assembly,
Reassemble and perform SCP 6
Replace these components in order until the error is corrected.
1. Feed Assembly, PL 8.40 Item 10
2. Pick Assembly, PL 8.20 Item 17
5/2011
2-44
7.25) and reseat CN7 on the Feeder Board, then retest.
REP 8.42.
Final Actions.
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual