Out Of Staples Rap - Xerox Phaser 4620 Service Manual

12-605-00 Staples Low RAP
12-605-00 The Staple Cartridge is near empty as indicated by the low staple sensor in the Sta-
pler.
BSD-Reference: WD 17
Initial Actions
• Reseat the Staple Cartridge.
• Replace the Staple Cartridge.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
NOTE: Remove the Stacker Shield Assembly,
Cycle system power. The error message is displayed.
Y N
Perform SCP 6 Final Actions.
Select dC330 code 12-860 to test the low staple sensor. The sensor signal changes (high/
low) as the staple cartridge is installed or removed.
Y N
Remove the Finisher, GP 14 to check the condition of the Finisher option connector and
harness. The connector and harness are undamaged.
Y N
Replace the sensor or repair the harness.
Check Stapler harness connections. The sensor is connected and the harness
undamaged.
Y N
Repair or reconnect the harness.
Replace the Stapler, REP 12.14. The error message is displayed.
Y N
Reassembly and perform SCP 6
Replace the Finisher Control Board,
Replace these components in order until the error is corrected.
1. IOT Upper Option Harness, PL 10.30 Item 24
2. MCU Board, PL 3.10 Item 3
Status Indicator RAPS
12-605-00, 12-610-00, 12-855-00
WARNING
REP 12.24 to access the Stapler harness.
Final Actions.
REP 12.2.

12-610-00, 12-855-00 Out of Staples RAP

12-610-00 The Stapler Cartridge is empty as indicated by the Stapler self priming sensor.
12-855-00 The Stapler is not properly primed with staples as reported by the self priming sen-
sor.
BSD-Reference: WD 17
Initial Actions
• Reseat the Staple Cartridge.
• Replace the Staple Cartridge.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
NOTE: Remove the Stacker Shield Assembly,
Cycle system power. The error message is displayed.
Y N
Perform SCP 6 Final Actions.
Select dC330 code 12-855 to test the self priming sensor. The sensor signal changes as the
staple cartridge is installed or removed.
Y N
Remove the Finisher, GP 14
harness. The connector and harness are undamaged.
Y N
Replace the sensor or repair the harness.
Check Stapler harness connections. The sensor is connected and the harness
undamaged.
Y N
Repair or reconnect the harness.
Replace the Stapler, REP 12.14. The error message is displayed.
Y N
Reassembly and perform
Replace the Finisher Control Board,
Replace these components in order until the error is corrected.
1. IOT Upper Option Harness, PL 10.30 Item 24
2. MCU Board, PL 3.10 Item 3
5/2011
2-60
WARNING
REP 12.24 to access the Stapler harness.
to check the condition of the Finisher option connector and
SCP 6 Final Actions.
REP 12.2.
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual