Gp 15 How To Safely Lift Or Move Heavy Modules; Gp 16 Machine Lubrication - Xerox Phaser 4620 Service Manual

GP 15 How to Safely Lift or Move Heavy Modules

Use this procedure when lifting or moving heavy modules.
Description
Most service procedures for optional feeder modules require separation of the printer and feed-
ers. Removal of the printer from the feeder requires 2 people. The Mailbox and Finisher mod-
ules only require 1 person for removal.
Mandatory safety warning. This procedure must be performed by 2 people. The module
is heavy.
Always move the printer separately from the Finisher, Mailbox, and optional trays.
Failure to properly repackage the printer for shipment can result in damage to the printer.
Printer damage caused by improper packaging is not covered by the Xerox warranty, service
agreement, or Total Satisfaction Guarantee.
When removing heavy modules from the machine, observe the following:
1. Ensure that a suitable stable surface to support the module after removal is located in
close proximity to the machine.
2. Ensure the support surface height is between 750mm and 1000mm (30 inches and 39
inches).
3. Ensure there are no hazards or obstacles between the machine and the support surface.
4. Two people are required if the module is to be lifted on to the floor or lifted from the floor.
Figure 1 Printer lifting technique
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
WARNING
CAUTION
CAUTION

GP 16 Machine Lubrication

Purpose
To give information on the use of lubricants.
Procedure
Only use lubricants as directed. Incorrect use of lubricants could seriously affect the perfor-
mance of the machine.
Take the following precautions when performing machine lubrication:
• Wear disposable gloves.
• Only use lubricants that are specified in the Parts List.
• Only lubricate parts of the machine as directed in the relevant RAPs, Repairs and Adjust-
ments etc.
• Apply only the smallest amount of lubricant, sufficient to lubricate the parts. To prevent
contamination, remove any surplus lubricant before the machine is run.
• Take great care not to contaminate other parts of the machine with the lubricant.
5/2011
6-15
CAUTION
General Procedures/Information
GP 15, GP 16