Tray 5 Is Open Rap - Xerox Phaser 4620 Service Manual

07-420-00 Tray 5 is Open RAP

07-420-00 The Size Switch indicates Tray 5 is not completely installed.
BSD-Reference: WD 13
Initial Actions
1. Close the Tray.
2. Check the Size Switch.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Remove Tray 5 and inspect the Size Switch. The Size Switch is undamaged.
Y N
Replace the Size Switch, REP 7.30, then retest.
Select dC330 code 07-500 to test the switch. The switch signals change (open/closed).
Y N
Remove the Right Cover (REP 28.2) and reseat CN5 on the Feeder Board, then retest.
The sensor signal changes.
Y N
Replace the Feeder Board, REP
Reassemble and perform SCP 6 Final Actions.
Replace these components in order until the error is corrected.
1. Size Switch, PL 8.30 Item 9
2. Feeder Board, PL 8.30 Item 7
3. MCU Board, PL 3.10 Item 3
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
WARNING
7.28.
07-430-00, 07-431-00 Jam in Tray 5 RAP
07-430-00 Jam 0 in Tray 5. Media remains in the Tray 5 Pick-up Assembly.
07-431-00 Check Tray 5 Feed Area. Media remains at the Tray 5 Take Away Sensor.
BSD-Reference: WD 13
Initial Actions
1. Check for obstructions in the media path.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Nudger, Feed, and Separator Rollers for excessive wear or contamination. The
rollers are undamaged and clean.
Y N
Clean or replace the rollers.
Check for obstructions or debris in the media path. The media path is clear.
Y N
Clear the media path of obstructions or debris.
Check Tray 5 Pick Assembly (PL 8.20 Item
Y N
Repair improper pick assembly motion.
Select dC330 code 08-855 to test the Feed Clutch. The clutch is engaged (on/off).
Y N
Remove the Right Cover (REP
The clutch is engaged.
Y N
Replace the Feed Clutch,
Reassemble and perform SCP 6
Select dC330 code 08-950 to test the Feed Drive. The Feed Drive Assembly rotates (on/
off).
Y N
Remove the Right Cover (REP
The Feed Drive Assembly rotates.
Y N
Replace the Feed Drive Assembly,
Reassemble and perform SCP 6
Replace these components in order until the error is corrected.
1. Feed Assembly, PL 8.40 Item 10
5/2011
2-29
WARNING
17) motion. Pick assembly motion is good.
7.25) and reseat CN9 on the Feeder Board, then retest.
REP 8.41.
Final Actions.
7.25) and reseat CN7 on the Feeder Board, then retest.
REP 8.42.
Final Actions.
Status Indicator RAPS
07-420-00, 07-430-00, 07-431-00