Finisher Door Open Rap - Xerox Phaser 4620 Service Manual

01-500-00 Finisher Door Open RAP

01-500-00 The Finisher Rear Door is not latched.
BSD-Reference: WD 17
Initial Actions
• Close the Finisher Rear Door.
• Check for obstructions blocking the sensor.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Check the Rear Door sensor actuator. The actuator is undamaged.
Y N
Repair or replace the Finisher Rear Door,
Select dC330 code 12-895. The sensor is operational (high/low).
Y N
Remove the Finisher Top Cover (REP
Sensor (PL 12.35 Item 14). The sensor connection is secure.
Y N
Secure the Finisher Rear Door Open Sensor connection.
Check the Finisher option harness in the Finisher right cover. The harness is undam-
aged.
Y N
Repair or replace the Finisher option harness.
Replace the Finisher Rear Door Open Sensor,
Replace these components in order until the error is corrected.
1. Finisher Rear Door Open Sensor, PL 12.35 Item 14
2. Finisher Control Board, PL 12.15 Item 2
3. IOT Upper Option Harness, PL 10.30 Item 24
4. MCU Board, PL 3.10 Item 3
Status Indicator RAPS
01-500-00, 01-700-00
WARNING
REP 12.17.
12.18) and check the Finisher Rear Door Open
REP 12.20.
01-700-00 Stapler Door Open RAP
01-700-00 The Staple Cartridge Door is not latched securely.
BSD-Reference: WD 17
Initial Actions
• Close and latch the Staple Cartridge Door.
• Check for obstructions blocking the interlock switch.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Check the Staple Cartridge Door interlock actuator. The actuator is undamaged.
Y N
Repair or replace the Finisher right cover,
Select dC330 code 12-870. The switch is operational (high/low).
Y N
Replace the Staple Cartridge Door Interlock Switch,
Remove the Finisher Right Cover
Switch (PL 12.45 Item 4). The switch connections are secure.
Y N
Secure the Staple Cartridge Door Interlock Switch connections.
Check the Finisher option harness in the Finisher right cover. The harness is undamaged.
Y N
Repair or replace the Finisher option harness.
Replace these components in order until the error is corrected.
1. Staple Cartridge Door Interlock Switch
2. Finisher Control Board, PL 12.15 Item 2
3. IOT Upper Option Harness, PL 10.30 Item 24
4. MCU Board, PL 3.10 Item 3
5/2011
2-4
WARNING
REP 12.11.
REP 12.13.
(REP 12.11) and check the Staple Cartridge Door Interlock
(PL 12.45 Item 4)
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual