Paper Empty At Tray 5 - Xerox Phaser 4620 Service Manual

2. Pick Assembly, PL 8.20 Item 17
Status Indicator RAPS
07-330-00, 07-331-00, 07-410-00

07-410-00 Paper Empty at Tray 5

07-700-00 The No Paper Sensor indicates Tray 5 is empty.
BSD-Reference: WD 13
Initial Actions
1. Check the No Paper Sensor Actuator.
2. Check for obstruction of the Pick mechanism.
Procedure
Use safe handling procedures when removing the module. Refer to
is heavy.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the No Paper Sensor Actuator. The actuator is undamaged and motion is good.
Y N
Repair or replace the Tray 5 No Paper Sensor Actuator.
Select dC330 code 07-510 to test the sensor. The sensor signal changes (high/low).
Y N
Remove the IOT, Tray 3 and Tray 4. Check the option harness connections. The
ness connectors are undamaged.
Y N
Replace any damaged harnesses.
Reassemble the system to exchange Feeder positions. The error changes to the new
feeder position.
Y N
Check the IOT Lower Option Harness. The harness is undamaged.
Y N
Replace the Lower Option Harness,
Replace the MCU Board,
Replace the No Paper Sensor
Y N
Remove the Right Cover
retest. The sensor signal changes.
Y N
Replace the Feeder Board,
Reassemble and perform
Reassemble and perform SCP 6
Replace the MCU Board, REP 3.4.
5/2011
2-28
WARNING
GP
WARNING
REP 10.5.
REP 3.4.
(REP 7.35), then retest. The signal changes.
(REP 28.2) and reseat CN3 on the Feeder Board, then
REP 7.28.
SCP 6 Final Actions.
Final Actions.
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
15. The module
har-