Mailbox Rear Door Open Rap - Xerox Phaser 4620 Service Manual

01-900-00 Mailbox Rear Door Open RAP

01-900-00 The Mailbox Rear Door is not latched securely.
BSD-Reference: WD 18
Initial Actions
• Close the Mailbox Rear Door.
• Check for obstructions blocking the interlock switch.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Check the Mailbox Rear Door interlock actuator. The actuator is undamaged.
Y N
Repair or replace the Mailbox rear door,
Select dC330 code 12-915. The switch is operational (high/low).
Y N
Replace the Mailbox Rear Door Interlock Switch,
Remove the Mailbox top cover (REP 11.12, step 5) and check the Rear Door Interlock Switch
(PL 11.30 Item 4). The switch connections are secure.
Y N
Secure the Mailbox Rear Door Interlock Switch connections.
Check the Mailbox option harness in the Mailbox right cover. The harness is undamaged.
Y N
Repair or replace the Mailbox option harness,
Replace these components in order until the error is corrected.
1. Mailbox Rear Door Interlock Switch,
2. Mailbox Control Board, PL 11.15 Item 1
3. IOT Upper Option Harness, PL 10.30 Item 24
4. MCU Board, PL 3.10 Item 3
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
WARNING
REP 11.4.
REP 11.13.
PL 11.15 Item 4.
PL 11.30 Item 4
03-100-00, 03-110-00 Finisher Interface Error RAP
03-100-00 Communications between the Finisher and IOT has failed.
03-110-00 Communications between the Finisher and IOT has failed.
BSD-Reference: WD 17
Initial Actions
• Reseat the Finisher on the IOT connection.
• Check for obstructions or damage to the interface connection.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Remove the Finisher right cover (REP
undamaged.
Y N
Repair or replace the Finisher option harness.
Check the IOT Upper Option Harness. The harness is undamaged.
Y N
Repair or replace the Upper Option Harness,
Replace these components in order until the error is corrected.
1. Finisher Control Board, PL 12.15 Item 2
2. MCU Board, PL 3.10 Item 3
5/2011
2-5
WARNING
12.11) and check the option harness. The harness is
REP 10.4.
Status Indicator RAPS
01-900-00, 03-100-00, 03-110-00