Rep 7.6 Tray 2 Feeder Assembly - Xerox Phaser 4620 Service Manual

Figure 5 Tray 1 No Paper Sensor actuator position
Repairs
REP 7.5, REP 7.6

REP 7.6 Tray 2 Feeder Assembly

Parts List on PL 8.15 Item 21
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cover the Drum Cartridge to prevent light exposure.
NOTE: To service or replace the Tray 2 Feeder Assembly requires separation of the left side
chassis. With the left side chassis separated, the chassis is prone to collapse, As you release
the left side chassis, use a prop placed in the Tray 2 cavity to maintain, as best as possible,
chassis alignment.
1. Remove Tray 2.
2. Open the Top Door.
3. Remove the Toner Cartridge.
4. Remove the Drum Cartridge.
5. Remove the Duplex Unit, REP
6. Remove the IP Board Cover,
7. Remove the Right Cover, REP
8. Remove the Top Cover, REP
9. Remove 5 screws (2 plastic, 3 metal) that secure the rear support bracket to the chassis.
10. Lift the bracket and rest on the printer chassis,
5/2011
4-30
WARNING
CAUTION
10.1.
REP 28.1.
28.2.
28.5.
Figure 1.
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual