REP 10.5 Lower Option Harness
Parts List on
PL 3.10
Removal
Use safe handling procedures when removing the module. Refer to
is heavy.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1.
Remove the IOT from Tray 3, if installed.
2.
Remove the Duplex Unit,
REP
10.1.
3.
Remove the Right Cover,
REP
28.2.
4.
Disconnect CN15 from the MCU Board,
Figure 1 Disconnect CN15 from the MCU Board
5.
Move the printer so the right side overhangs the edge of the work surface.
6.
Remove 2 screws (metal) that secure the connector to the chassis,
Repairs
REP 10.5
WARNING
GP
15. The module
WARNING
Figure
1.
Figure 2 Remove the Lower Option Connector
5/2011
4-86
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual