Tray 3 Lift Error Rap - Xerox Phaser 4620 Service Manual

A
Test Lift Motor operation in the affected Feeder. The Lift Motor rotates.
Y N
Remove the Right Cover (REP 7.25), reseat CN2 on the Feeder Board, then retest. The
Lift Motor rotates.
Y N
Check the Feeder Option Harness. The connectors are undamaged.
Y N
Repair or replace the affected harness,
Replace the Lift Motor, REP 7.7, then retest. The Lift Motor rotates.
Y N
Replace the Feeder Board,
Reassemble and perform SCP 6
Reassemble and perform SCP 6 Final Actions.
Check the affected Feeder's Upper Option Harness. The connector is undamaged.
Y N
Replace the Upper Option Connector,
Replace these components in order until the error is corrected.
1. Tray, PL 7.10 Item 23
2. Feeder Board, PL 8.30 Item 7
3. MCU Board, PL 3.10 Item 3
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
REP 7.31, REP 7.32.
REP 7.28.
Final Actions.
REP 7.31.

04-200-00 Tray 3 Lift Error RAP

04-200-00 Tray 3 Level Sensor did not change state within 13 seconds of Lift Motor activation.
BSD-Reference: WD 13
Initial Actions
• Remove and replace Tray 3.
• Check for obstructions blocking bottom plate movement.
Procedure
Use safe handling procedures when removing the module. Refer to
is heavy.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Check Tray 3 bottom plate linkage and sector gear condition. Use an alternate Tray to test lift
operation.The Tray is undamaged.
Y N
Replace the Tray.
Check the Pick Assembly (PL 8.20) motion. Pick assembly motion is good.
Y N
Repair improper pick assembly motion.
Select dC330 code 07-350. The sensor is operational (high/low).
Y N
Repair or replace the Level Sensor,
Check the Lift Gear, PL 8.35 Item 4. The gear is undamaged and properly installed.
Y N
Replace the Lift Gear, REP 7.8.
Test Lift Motor operation. The Lift Motor rotates.
Y N
Remove the Right Cover (REP
Lift Motor rotates.
Y N
Check the Feeder Upper Option Harness. The harness is undamaged.
Y N
Repair or replace the harness,
Replace the Lift Motor, REP
A B
5/2011
2-17
WARNING
GP 15. The module
WARNING
REP 7.37.
7.25), reseat CN2 on the Feeder Board, then retest. The
REP 7.31.
7.7, then retest. The Lift Motor rotates.
Status Indicator RAPS
04-110-00, 04-200-00