REP 12.3 Finisher Stacker Full Sensor
Parts List on
PL 12.15 Item 3
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1.
Separate the Finisher from the printer,
2.
Remove the left cover,
REP
12.1.
3.
Remove 4 screws (2 metal, 2 plastic) that secure the Control Board bracket to the Fin-
isher,
Figure
1.
Figure 1 Remove the Control Board bracket screw,
4.
Release the harness clamp and lift the front of the bracket,
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
WARNING
GP
14.
Figure
2.
Figure 2 Position the Control Board bracket
5.
Disconnect P/J113 from the Stacker Full Sensor and release the 3 hooks to remove the
sensor,
Figure
3.
5/2011
4-129
Repairs
REP 12.3