Xerox Phaser 4620 Service Manual page 75

09-500-00 Toner Cartridge Not Installed RAP
09-500-00 The toner cartridge is not installed or the CRUM did not properly connect.
BSD-Reference: WD 7
Initial Actions
• Cycle system power.
• Replace the Toner Cartridge.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Toner Cartridge CRUM connection. The connection is clean and undamaged.
Y N
Cycle system power. The error message is displayed.
Y N
Reassemble and perform SCP 6
Replace the Toner Cartridge. The error message is displayed.
Y N
Reassemble and perform SCP 6
Remove the Right Cover (REP 28.2) and reseat CN2 on the MCU Board. The
message is displayed.
Y N
Reassemble and perform SCP 6
Replace the MCU Board, REP 9.8.
Remove the Left Cover (REP 28.3) and check the CRUM harness. The
nected and undamaged.
Y N
Repair or reconnect the harness.
Replace these components in order until the error is corrected.
1. Joint Board, PL 9.15 Item 7
2. MCU Board, PL 3.10 Item 3
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
WARNING
Final Actions.
Final Actions.
Final Actions.
harness
09-508-00 Waste Toner Cartridge Near Full RAP
09-508-00 Waste Toner Cartridge is near end of life.
BSD-Reference: WD 7
Initial Actions
• Replace the Waste Toner Cartridge.
• Check for dust or toner blocking the sensor window on the cartridge.
Procedure
A replacement Waste Toner Cartridge is included with each new Toner Cartridge. When install-
ing a new Toner Cartridge, install the new Waste Toner Cartridge. When this error occurs,
replace both components.
error
is con-
5/2011
2-51
Status Indicator RAPS
09-500-00, 09-508-00