Tray 2 Is Missing (When Inserted) - Xerox ColorQube 8570 Service Manual

Tray 2 is Missing (when inserted)

A Tray 2 error has occurred. The following troubleshooting procedure applies to this error.
Initial Actions
• Remove the tray and inspect the tray cavity to ensure that it is free of obstructions or
debris.
• If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Part (Chapter 5 - Parts List)
• Paper Size Switch, PL 6.1 Item 1
Wiring and Plug/Jack References (Chapter 7 - Wiring Data)
• Figure 5, I/O Board P/J Locations
• Figure 8, I/O Board, Sensors (1 of 2)
Procedure
Check the Paper Size Switch wiring connector
connection secure and undamaged?
Y N
Reseat and/or replace the wiring harness.
Replace the Paper Size Switch (REP 6.1).
Fault Messages and Codes
Tray 2 is Missing, Unload Output Tray (when not full)
P/J701 for damage or being unplugged. Is the
Unload Output Tray (when not full)
An Output Tray error has occurred. The following troubleshooting procedure applies to this
error.
Initial Actions
• Remove all paper from the Output Tray.
• If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Parts (Chapter 5 - Parts List)
• Exit Assembly, PL 3.1 Item 13
• Engine Exit Flag, PL 6.1 Item 8
Wiring and Plug/Jack References (Chapter 7 - Wiring Data)
• Figure 1, Right Side Wire Routing
• Figure 8, I/O Board, Sensors (1 of 2)
Procedure
Check the Exit Flag for free movement. Is the Flag bent, warped, or unseated?
Y N
Check the Exit Flag wiring harness connector P/J601. Is the connection secure and
undamaged?
Y N
Reseat and/or replace the wiring harness.
Replace the Exit Assembly
Reseat or replace the Exit Flag.
October 2012
2-94
(REP 3.13).
Revised, 3rd Revision - Xerox Internal Use Only
ColorQube 8570/8870 Service Manual