Updating Program - Furuno FS-1575 Service Manual

2. IB-583 updating program
IB-583 programs can be updated from the [DTE] port or the floppy disk drive of the
IB-583 terminal unit.
*** Updating from the [DTE] port ***
Procedure)
1. Turn OFF the power of the IB-583 terminal unit.
2. Connect the serial port of the PC to the [DTE] port of the IB-583 terminal unit with
9-pin D-sub straight cable.
PC
3. Double-click the icon of the batch file "UP583.BAT" of the program to be updated.
4. When the "[Waiting For Target Wake up ...] Time : x (sec)" popup window appears
on the Command Prompt Window of the PC, turn ON the power of the IB-583
terminal unit within a period of 25 seconds after the popup window appears.
After a lapse of 25 seconds, an error message saying "Time Out Error !" will appear,
In this case, hold down the [Ctrl] key and press the [C] key to exit from the
Command Prompt window once, and then follow the procedure from Step 3 again
to update the program.
5. The program update will automatically be initiated.
6. Upon completion of the program update, a message saying "Update Complete" will
appear, followed by the normal NBDP window.
7. Turn OFF the power once to reset the system.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
COM Serial Port
(RS-232C)
DCD 1
RxD 2
TxD 3
DTR 4
GND 5
DSR 6
RTS 7
CTS 8
RI 9
9 pin D-sub
(female)
(male)
8-14
8.2 NBDP Terminal Updating Program
[DTE] IB-583
1
N.C
2
TXD
3 RXD
4
5 GND
6
7
8
9
9 pin D-sub
(male)