4.9 WR1 and WR2 Board Jumper Setting
To Use FAX-5: pre-amplifier unit to WR1 and WR2 antenna, be sure to set JP3 on the
WR1 and WR2 boards to [ACTIVE] side and supply +12V power to the FAX-5.
The factory set is [WIRE].
• WR1: DSC watch receiver
• WR2: General DSC frequency watch receiver (Option)
WR2
WR1
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
1
J3: [ACTIVE]
1-2: Active (+12V)
2-3: Wire
4-90
4.9 WR1 and WR2 Board Jumper Setting
When ANT WR1 and WR2 output +12V
power;
JP3 on the WR1 and WR2 boards are
already set to [ACTIVE], respectively.
2
3