Editing User Ch Registered; Searching User Ch Registered [7]: Band; Reflecting Channel Selected On The Rt Window [8]: Rt Set - Furuno FS-1575 Service Manual

4. Editing USER CH registered

Procedure)
1. Select a channel to be edited on the "USER CH" window.
2. Press the [ENTER] knob. The "USER CH ENTRY" window will appear.
3. Make a change to the content of registration following the procedure for "1.
Registering USER CH," put the cursor on <REGISTER>, and then press the
[ENTER] knob. A message saying "Channel number overlaps." will appear.
4. Click "Yes," and then press the [ENTER] knob.
The content of the channel selected will be replaced with that edited.

5. Searching USER CH registered [7]: BAND

Select a MODE to be searched on the "USER CH" window.
Press the [7]: BAND key. A window displaying the following "BAND" will appear.
Select a BAND to be searched, and then press the [ENTER] knob.
The cursor will move to the youngest channel number registered on its BAND. Then,
search a channel to be selected with the channel knob.

6. Reflecting channel selected on the RT window [8]: RT SET

On the "USER CH" window, select a channel used to perform communication from the
USER CH LIST in SSB mode. Then, press the [8]: RT SET key. The window will be
switched to the "RT" window to reflect the channel selected on the RT window.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
4-9
4.2 USER CH