4.1.2 MMSI CLEAR
Procedure)
1. Press and hold [S1]: MMSI switch on the T-IF board for a period of four seconds or
more. The "MMSI SETUP" window will appear.
2. Enter the password: XXXXXX, click on "◂ [CLEAR]," and press the [ENTER]
knob.
3. The dialog box "MMSI Clear OK?" will appear. Click "Yes," and then press the
[ENTER] knob. The MMSI setting will be cleared.
4. Click on "MMSI," enter a new MMSI, and then press the [ENTER] knob.
To exit this window, press the [CANCEL] key.
4.1.3 CLEAR ALL
Executing CLEAR ALL will initialize all settings except for MMSI and MAC
address settings. When this menu is executed, the said settings should be
made again.
Procedure)
1. Press and hold [S1]: MMSI switch on the T-IF board for a period of four seconds or
more. The "MMSI SETUP" window will appear.
2. Enter the password: XXXXXX, click on "CLEAR ALL," and press the [ENTER]
knob.
3. The dialog box "MMSI Clear OK?" will appear. Click "Yes," and then press the
[ENTER] knob. The window will fade out to execute the "CLEAR ALL" menu.
Subsequently, a message saying "Initializing..." will appear and the RT window will
open.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
4.1 MMSI Setting and CLEAR ALL
4-4