Key Assign] - Furuno FS-1575 Service Manual

4.3.2 [2. KEY ASSIGN]

This submenu allows the assignment of specific functions to [1], [4], and [7] keys.
The functions to be assigned are as listed in the table shown below. The functions can
be set by each unit of FS-2575C.
Note)
When [MENU] -> 9.SERVICE -> 3.RT SETUP -> 1.SETUP -> SELCALL ->
ENABLE is selected, F3: [7] key will be automatically assigned to SELCALL and the
display of "F3" will be cleared from the "KEY ASSIGN" Key Selection window.
Function
- - - - Disables the assignment of function keys.
Displays a popup window used to make TX frequency setting.
TX/RX FREQ Once TX frequency has been set, the same frequency is set to RX
frequency. This function allows individual RX frequency setting.
Displays a popup window used to make RX frequency setting.
RX FREQ Even if RX frequency is set, TX frequency will remain unchanged.
However, once TX frequency has been set, RX frequency also changes.
MODE Displays a popup window used to select a MODE.
AGC Displays a popup window used to select AGC.
TX PWR Displays a popup window used to select TX POWER.
Sets transmission frequency to reception frequency every time the key is
TX MONITOR pressed in case of communications using different frequency band
(S-DUP, DUP).
"2. MSG FILE" window opens when [MENU] -> 6. DSC is selected. TEST
is selected in the File tab. To make a test call;
1) select a station to make a TEST CALL from MSG FILE,
TEST CALL
2) click on [OTHER DSC MSG] to display the COMPOSE MESSAGE
window,
3) put the cursor on "GO TO CALL," and then press the [ENTER] knob.
"2. MSG FILE" window opens when [MENU] -> 6. DSC is selected. A tab
MSG FILE
that opened previously is selected in the FILE tab.
DAILY TEST Executes "1. DAILY TEST" when [MENU] -> 1. TEST is selected.
LOG Displays the "LOG" window when [MENU] -> 3 LOG is selected.
INTERCOM Executes "INTERCOM" when [MENU] -> 4. INTERCOM is selected.
Displays "CLARIFIER" regardless of whether CLARIFIER is set to "ON" or
CLARIFIER "OFF" when [MENU] -> 5.SYSTEM -> 7.RX SETUP -> CLARIFIER is
selected. CLARIFIER is enabled in SSB, CW, and LSB MODE.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
Table 4.3.2 List of KEY ASSIGN Setting Functions
Description
4-12
4.3 SYSTEM