Tx Pwr (Freq) - Furuno FS-1575 Service Manual

5.2.2 TX PWR (FREQ)

The Sub-menu "TX PWR (FREQ)" allows for making TX output power adjustment in
steps of 1 MHz.
Reference)
If frequencies and modes registered on the "USER CH" window fall within the
frequency band for which TX output power adjustment was made with the Sub-menu
"TX PWR (FREQ)" and the modes match each other, the relevant will be set as the
default of USER CH power data.
Procedure)
1. Select [MENU] -> 9.SERVICE -> 3.RT SETUP -> 4.TX PWR (FREQ), and then
press the [ENTER] knob.
2. The "TX POWER (FREQ)" window will appear.
Sub-menu Setting Parameter
SSB
DSC
NBDP
TX MODE
CW
TX FREQ 1605.0 to 27500.0
FS-5075
HIGH
TX POWER MID
LOW1
LOW2
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
5.2 T/R Unit Output Power Adjustment and Measurement
Table 5.2.1 Sub-menus of TX POWER (FREQ)
Remark
Selects a mode of frequency to be
transmitted.
CW:
Appears when selecting [MENU] ->
9. SERVICE -> 3. RT SETUP ->
1. SETUP -> CW -> "ENABLE."
Independent of selection of [MENU] ->
9. SERVICE -> 3. RT SETUP ->
TX FREQ.
FS-2575, 1575
HIGH
MID Selects an output reduction setting level.
LOW
5-15
Appears in case of FS-5075