3. Settings
Be sure to make the following settings:
3.1 MMSI Setting (See 4-3)
3.2 WR Jumper Setting (See 4-90)
To use a FAX-5 + 2.6m whip antenna for the WR antenna, change the setting of J3
jumper on the WR board to "ACTIVE." +12VDC power is supplied to the WR antenna
terminal.
3.3 RX ANT Setting (See 4-73)
Depending on the configuration of RX antenna, ensure the connection of RX antenna
route.
1) When RX ANT is installed (to receive via RX ANT or T/R ANT):
- Select [MENU] -> 9.SERVICE -> 3.RT SETUP -> 1.SETUP -> RX ANT ->
"CONNECT";
- Select [MENU] -> 5.SYSTEM -> 7.RT SETUP -> 2.ANT SELECT -> Any
mode; or
- Select [MENU] -> 9.SERVICE -> 3.RT SETUP -> 1.SETUP -> DIVIDER ->
"OFF".
2) When RX ANT is installed on the FS-5075 to operate Duplex communication:
- Select [MENU] -> 9.SERVICE -> 3.RT SETUP -> 1.SETUP -> RX ANT ->
"CONNECT";
- Select [MENU] -> 5.SYSTEM -> 7.RT SETUP -> 2.ANT SELECT -> RX
ANT; or
- Select [MENU] -> 9.SERVICE -> 3.RT SETUP -> 1.SETUP -> DIVIDER ->
"OFF."
Note)
Be sure to mount the DUP FIL board and change connectors on the DUP FIL
and RX FIL boards.
3) When RX ANT is not mounted (to transceiver via T/R ANT):
- Select [MENU] -> 9.SERVICE -> 3.RT SETUP -> 1.SETUP -> RX ANT ->
"DISCONNECT"; or
- Select [MENU] -> 9.SERVICE -> 3.RT SETUP -> 1.SETUP -> DIVIDER ->
"OFF."
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
4
Summary