Tx Pwr (User Ch) - Furuno FS-1575 Service Manual

Returning power data in the registered frequency band to the default
1. Select on <LOAD DEFAULT> on the "TX POWER (FREQ)" window, and then
press the [ENTER] knob.
2. A message saying "Default Setting OK?" will be popped up. Select "YES," and
then press the [ENTER] knob. All data registered on the "TX POWER (FREQ)"
window will return to the default. For detail, refer to "Table 5.1.1 Power Data
Defaults."

5.2.3 TX PWR (USER CH)

The Sub-menu "TX PWR (USER CH)" is used to make adjustment of output power for
user-specified channels registered on the USER CH window. For the procedure for
registering on the USER CH window, refer to information on page 4-5.
Reference)
If frequencies and modes registered on the "USER CH" window fall within the
frequency band for which output power adjustment was made with the Sub-menu
"TX PWR (FREQ)" and the modes match each other, the relevant will be set as the
default of USER CH power data.
Procedure)
1. Select [MENU] -> 9.SERVICE -> 3.RT SETUP -> 5.TX PWR (USER CH), and
then press the [ENTER] knob.
2. The "TX POWER (FREQ)" window will appear.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
5.2 T/R Unit Output Power Adjustment and Measurement
5-17
Appears in case of FS-5075