Divider; Line In (-10/+10) 0; Line Out (-10/+10) 0; Format (Iec+Nmea, Iec) - Furuno FS-1575 Service Manual

11. DIVIDER

The Submenu-3 "DIVIDER" is used to select whether to set the DIVIDER circuit
incorporated in the RX FIL board to ON or OFF.
To connect the DIVIDER circuit from [DIV OUT-1, 2] of the RX FIL board to WR1,
WR2, and the antenna input port of the RX board, set "DIVIDER" to "ON." In this case,
be sure to make a change to the RX ANT connection path.
Refer to "Receiving Antenna Configuration" on page 4-73.
Note) When "DIVIDER" is set to "ON," do not use the [LPF OUT] output. Doing so
will result in a decreased reception level.

12. LINE IN (-10/+10) 0

The Submenu-3 "LINE IN" is used to make adjustment of #6: LINE-IN level of the
[REMOTE] port. For example, connect AF signal from the SELCALL system to the
LINE-IN signal. The input level adjustment range is 0 dBm/600 Ω ± 10 dBm.

13. LINE OUT (-10/+10) 0

The Submenu-3 "LINE OUT" is used to make adjustment of #6: LINE-OUT level of
the [REMOTE] port. For example, connect the LINE-OUT signal to the input terminal
of external receiver of the FAX receiver. The output level adjustment range is
0 dBm/600 Ω ± 10 dBm.

14. FORMAT (IEC+NMEA, IEC)

The Submenu-3 "FORMAT" is used to make setting of specification for sentences input
between #7 (TD) and #8 (RD) of TB7 on the T-IF board of the FS-xx75T.
Regardless of setting of this Submenu, the formatter handles GNS, GGA and RMC, and
GLL and ZDA in order of priority presented.
Furthermore, P-sentences can be transmitted and received regardless of this setting.
• IEC
Accepts IEC-61162-1 ed-4.0 compatible data.
The data is imported when the positional data status is "valid," but not imported
while in DR, MANUAL, or SIMULATOR mode, or when checking of the
checksum of the sentence, if any, results in an error.
• IEC+NMEA
Imports data compatible with IEC-61162-1 ed-4.0 and NMEA-0183 ver.-1.5, 2.0,
and 3.0, even while in DR or MANUAL mode, and further regardless of whether
checksum is provided.
However, the data is not imported when checking of the checksum of the sentence,
if any, results in an error.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
4-79
4.7 SERVICE