Chapter 8. Updating Program; Fs-Xx75 Updating Program; Summary For Update - Furuno FS-1575 Service Manual

8.1 FS-xx75 Updating Program

8.1.1 Summary for Update

1. Since programs are updated via the LAN port, network connection (IP address)
setting should be made. For example, make IP address setting of a PC to be used for
the program update as shown below:
• IP address:
• Subnet mask:
• Default gateway:
To check for the network address, select [MENU] -> 5.SYSTEM -> 9.NETWORK.
Or program are update via the serial port: NBDP of FS-2575C. See page 8-22.
Note)
Program folder for LAN: LANuppg, for Serial: SIOuppg
2. When two FS-2575C units are installed, programs will be automatically updated in
order of No. 1 FS-2575C and No. 2 FS-2575C.
3. Memory clear or other action is not needed. Furthermore, even if a program is
updated, saved log files and system set values will not be cleared.
However, if any change is made to the file structure, the item changed will be only
cleared and a default will be set.
4. If combinations of T-CPU program of FS-xx75T, C-CPU program of FS-2575C,
and 78K CPU (for NBDP) program are different, the C-CPU and 78K CPU
programs will be automatically downloaded from T-CPU so as to combine
programs centering on the T-CPU program.
The C-CPU program is downloaded after completion of updating the T-CPU
program or 40 seconds after turning ON the power, and after a lapse of another
40 seconds, the 78K CPU program is downloaded.
Note) The 78K CPU program is used for NBDP communication. This program
consists of an application program and BOOT program used to boot the
system.
5. When programs of the same version are updated, the T-CPU program will be
overwritten, but the C-CPU program will not be rewritten.
6. Do not turn OFF the power during program transfer. If the power supply turns OFF,
update the program again.
7. To delete the program of the FS-2575C unit, select [MENU] -> 9.SERVICE -> 7.
OTHER -> SOFTWARE ERASE.
After a while, T-CPU will download a program to C-CPU.
8. The updated log of the C-CPU program can be checked by selecting [MENU] -> 9.
SERVICE -> 6.MAINTENANCE LOG -> 3.SW UPDATE LOG.
The program version and date (e.g. 01.00 20110902) of the C-CPU program are
displayed.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.

Chapter 8. Updating Program

172.31.5.1
255.255.0.0
No setting is needed.
8-1
8.1 FS-xx75 Updating Program