To Share With T/R Ant - Furuno FS-1575 Service Manual

Ssb radiotelephone

Hide thumbs Also See for FS-1575:

Table of Contents

2. To share with T/R ANT

For antenna circuit diagram, refer to "Receiving Antenna Configuration" on page 4-73.

1) Mount the WR2 board with four screws.

2) Put the mini-pin connector (L-200) in [J4] on the WR2 board and [J3] on the TX

board, respectively.

3) Relocate the mini-pin connector on the RX FIL board from between [J3: LPF OUT]

and [J4: BPF IN] to between [J4: BPF IN] and [J5: DIV OUT 1].

4) Put the mini-pin connector (L-380: standard supply) in [J2] on the WR2 board and

[J6: DIV OUT 2] on the RX FIL board, respectively.

5) Set JP1 on the WR2 board to [WIRE] side.

6) Select [MENU] -> 9.SERVICE -> 3.RT SETUP -> 1.SETUP -> DIVIDER ->

CONFIDENTIAL (internal use only)

This confidential document is used only by FURUNO authorized persons.

It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.

4.8 Mounting of WR2 Board

Refer to page 4-74.

Fig. 4.8.2 WR2 Cable Connection -2

Fs-2575 Fs-5075