Program Updating Procedure - Furuno FS-1575 Service Manual

8.1.4 Program Updating Procedure

Update a program according to the following procedure:
Step-1)
Make setting of network connection (IP address) of a PC, and then connect the PC
to the FS-xx75 system with a LAN cable.
Step-2)
Click on "BAT File: nUP_ FSXX75.bat," and then turn ON the power of the
FS-xx75 system. It takes 40 seconds at maximum to establish the network
connection between the PC and the FS-xx75 system.
Step-3)
A program will be transferred from the PC to the T-CPU of the FS-xx75T unit and
the program of the T-CPU will be updated.
Step-4)
After a lapse of approximately 40 seconds, the program of the T-CPU will be
updated to that of the C-CPU of the No. 1 FS-2575C unit. Upon completion, the
program of C-CPU of the No. 2 FS-2575C unit will be updated.
However, if the C-CPU program in the updated programs is the same as the
program of the C-CPU connected, this step will be skipped.
Step-5)
After a lapse of another 40 seconds or so, the program of the T-CPU will be
updated to that of the 78K CPU (used for NBDP) mounted on the T-CPU.
However, if the 78K CPU program in the updated programs is the same as the
program of the 78K CPU installed, this step will be skipped.
It takes approximately 8 minutes to update all programs aforementioned.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
8.1 FS-xx75 Updating Program
8-5