Energy Saver Mode; Entering The Energy Saver Mode - Fuji Xerox ApeosPort-V C5575 User Manual

2 Product Overview

Energy Saver Mode

The machine is equipped with the Energy Saver mode that saves electricity by reducing
power consumption.
The Energy Saver feature has two modes: Low Power mode and Sleep mode.
Low Power Mode
In this mode, the power to the control panel is lowered to save power.
Note
Sleep Mode
In this mode, the power supply to devices such as hard disk drive is suspended and the power
is lowered more than in the Low Power mode.
2

Entering the Energy Saver Mode

When the machine enters the Energy Saver mode, the touch screen is lit off and the <Energy
Saver> button on the control panel is lit on.
The machine enters the Energy Saver mode by the following instances:
Note
66
• When the machine enters the low power mode, the power supply to the fusing unit is suspended.
Pressing the <Energy Saver> button
The machine is not operated, data is not received, or a job is not processed until the
machine enters the Energy Saver mode.
Smart WelcomEyes does not detect human presence until the machine enters the Energy
Saver mode.
• When the machine displays an error such as paper jams and, it does not enter the Energy Saver
mode.
• When the machine enters the Energy Saver mode while a user is authenticated, the machine exits
the authentication mode.
• When the <Energy Saver> button is pressed, the machine enters the Energy Saver mode after 5
seconds.
• When you press the <Energy Saver> button soon after the touch screen is lit off and when the
machine does not enter the Energy Saver mode completely, it may take time to exit the mode. Wait
a few seconds until the machine is ready to exit the Energy Saver mode and push the <Energy
Saver> button again.
• The machine will not enter the Energy Saver mode when [Skip Blank Pages] is enabled. For
information on [Skip Blank Pages], refer to "5 Tools" > "Fax Service Settings" > "Fax Control" > "Skip
Blank Pages" in the Administrator Guide.
• Sufficient distance from the machine is required to keep the energy saving state after pressing the
<Energy Saver> button. When the specified period of time elapses after pressing the button, the
human motion sensor of the machine starts to detect human presence and then releases the Energy
Saver mode.