Energy Saver Mode - Fuji Xerox ApeosPort-IV C5575 Administration Manual

Energy Saver Mode

The machine is equipped with the Energy Saver mode that reduces the power consumption
by saving the electricity to the machine when no copy or print data is received for a specified
time.
The Energy Saver has two modes: the Low Power mode and the Sleep mode.
When you press the <Energy Saver> button or do not use the machine for a specified period
of time, the machine enters the Low Power mode.
When time exceeds the time specified in the Low Power mode, the machine then enters the
Sleep mode.
Press the <Energy Saver> button on the control panel to enter the Energy Saver mode.
It extinguishes the touch screen and lights up the <Energy Saver> button on the control
panel. To activate the machine, press the <Energy Saver> button. Pressing the <Energy
Saver> button extinguishes the light and deactivates the Energy Saver mode.
Note
Low Power Mode
The Low Power mode reduces the power to the control panel and the fusing unit.
It extinguishes the touch screen and lights up the <Energy Saver> button on the control
panel. To activate the machine, press the <Energy Saver> button. Pressing the <Energy
Saver> button turns off the light and deactivates the Energy Saver mode.
Note
Sleep Mode
The Sleep mode reduces the power to the machine even more than the Low Power mode.
It turns off the touch screen and lights up the <Energy Saver> button on the control panel.
To activate the machine, press the <Energy Saver> button. Pressing the <Energy Saver>
button turns off the light and deactivates the Energy Saver mode.
It takes longer time than the Low Power mode to deactivate the Sleep mode and enable to
use the machine.
Note
• When the following device is connected to the machine and a user operates the device, the Low
Power mode can be deactivated without pressing the <Energy Saver> button. If the machine is in
the Sleep mode, however, the Sleep mode will not be deactivated by the following operation. Set the
time long to elapse until the machine enters the Sleep mode from the Low Power mode. For
information on how to change the interval to enter the Low Power mode and Sleep mode, refer to
"Changing the Interval for Entering Energy Saver Mode" (P.24).
- Touch the card to IC Card Reader (optional)
• When the machine is in the Authentication mode, the Authentication mode is exited once the
machine enters the Low Power mode.
• While the machine is in the Low Power mode, the power supply to the fusing unit is also reduced.
• When you press the <Energy Saver> button during the Energy Saver mode, the touch screen lights
up. At this point, the scanner and the output devices remain the Energy Saver mode. Afterwards, by
operations such as using the touch screen, opening or closing of the document cover, and loading
paper in the document feeder, you can make the devices necessary to activate the machine exit the
Energy Saver mode and make the machine ready to start exiting the Energy Saver mode.
• When you make the machine exit Energy Saver mode by pressing the <Energy Saver> button, the
machine does not immediately identify the movements such as opening or closing of the front
cover. To make the machine identify these operations, exit all Energy Saver mode by operating the
control panel (for example, pressing the <Machine Status> button) before opening the front cover.
• If you replace toner cartridges or supply paper during the Energy Saver mode, the machine does not
identify these changes. Before performing these operations, exit Energy Saver mode by pressing the
<Energy Saver> button and the <Machine Status> button on the control panel.
• The Energy Saver mode is not exited by the following operations:
- Charge Print
- Secure Print
- Delayed Print

Energy Saver Mode

1
23