9.3
Legrests with Single Footboard.
1
16
19
17
1 Legrests, complete
4 Insert tube 18,5 mm, left
7 Calf belt
10 Cap nut M8
13 Caps A8
16 Hinge bolt 7,8x30 mm
19 Legrest locking device,
spring-weighed
I I n n s s p p e e c c t t i i o o n n
Calf belt missing or damaged?
Screwings loose?
Rubber mat damaged?
Footboard damaged?
Footboard receptacle damaged?
Weldment joints or insert tube defective?
Weldment joints or upper part of legrest defective?
Slide pieces or caps missing or damaged?
Complete Disassembly
Remove calf belt (7) from insert tubes (3 and 4).
Hold footboard (5) by its left side and turn upwards until it is released from the left insert tube (4).
Release legrest locking (19) and lift legrest (1) from the hinge bolts (16 and 17).
Loosen cap nut (10) and pull the legrest upper part (e.g. 2) from the insert tube (3 or 4).
Loosen clamp (8) and detach from the legrest upper part (2).
Unscrew tapping screw (15) completely and pull insert tube (3) out of the footboard (5).
Remove leaf spring (14) from the footboard (5).
If necessary, remove slide part (12) and caps (13) from the insert tubes (3 and 4).
Assembly
The assembly is performed in the reverse order.
Legrests,
assembled
7
6
5
2 Legrest upper part, left
5 Sport footboard (ALU)
8 Clamp 22 mm
11 Washer 8,4x17x1,6
14 Leaf spring
17 Hinge bolt 7,8x35 mm
2
10
7
13
3
12
15
3 Insert tube 18,5 mm, right
6 Rubber mat, glued
9 Button-headed screw M8x25
12 Slide piece SL 18
15 Tapping screw 4,2x16
18 Plastic washers 7,8x20x1,0
R R e e m m e e d d y y
> Replace, exchange calf belt.
> Tighten screwings.
> Replace rubber mat.
> Replace footboard.
> Replace footboard receptacle.
> Replace insert tube.
> Replace footrest upper part.
> Replace, exchange slide pieces or caps.
NOTE:
When assembling, pay attention to the correct location
of the parts (left, right).
Insert leaf spring (14) correctly.
Adjust legrests to the same length.
Legrests,
9
disassembled
8
11
4
12
6
14
(locked in the footboard)
for hinge bolt
(not shown)
23
5