15.5 Disassembling Completely Headlight, Flasher and Lamp Holder
Front Lighting, assembled
3
10
1
4
5
4
12
1 Lamp holder
4 Connection and ground cable resp. 5 Screw M6x25 with washer
7 Tapping screw 2,9x15
10 Cable binder
13 Headlight glass with mirror
16 Flasher glass
NOTE:
The headlight lamp is provided with voltage via the lampholder (positive pole) and a separate
ground cable. The lamp holder contacts the contact spring in the headlight casing. The ground
cable is clamped into the lamp base.
The flasher lamp is provided with voltage via a twin-wire cable. The wires are soldered to the lamp
base.
CAUTION:
Disassembling headlight
Loosen tapping screw (7) completely and detach headlight glass (13).
Remove lamp base (not shown) from the headlight glass (13) and unscrew the lamp (not shown).
If required, pull ground cable (4) from the lamp base and remove base.
Loosen nut (15) completely and detach headlight casing (14) with washers from the lamp holder (1).
Assembly
The assembly is performed in the reverse order.
82
13
7
17
11
16
18
9
8
2
2 Flasher, complete
8 Tapping screw 3,5x10
11 Mirror with lamp base
14 Headlight casing
17 Flasher casing
When disassembling the headlight, flasher and lamp holder,
the batteries must be removed first.
>Danger of Short Circuit, Fire and Burning<.
Headlight
13
14
15
.
Front Lighting, disassembled
3
2
1
4
3 Flasher, complete
6 Rubber bushing with washer
9 Screw M5x8
12 Chassis
15 Lock nut M6 and washers
18 Flasher bulb
5
6