12.0 Check and Repair Work on the Power Supply
12.1 Testing Batteries, Battery Boxes and Battery Voltage
NOTE
Make sure that both batteries are charged.
If the total voltage is below 24 V, charge batteries
completely (see chapter 12.2).
If the battery voltage drops below 21 V during operation,
the driving speed will be reduced step by step to minimize
power consumption. If the voltage drops below 17 V, the
power supply will be cut off entirely.
The voltage of each individual battery should not be less
than 9.5 V.
A voltage drop can be checked during driving operation
with turned-on lighting and activated hand brake.
CAUTION:
Handle tools carefully. Do not bridge the battery poles.
Take into account the weight of the batteries of approx.
22 kg.
Detail: + Terminal
Master Fuse 50 A
NOTE:
Exact information on the condition of the batteries can be obtained by a
capacity test, which can only be performed by the manufacturer.
CAUTION:
For the replacement of batteries, use exclusively gel batteries brand
Sonnenschein. Type: Dryfit A 512 / 55A (INVACARE Item No.: P50 992)
I I n n s s p p e e c c t t i i o o n n
Voltage decreasing heavily under strain (driving operation,
hand brake applied and lights on)?
Total voltage below 24 V?
Voltage of one battery below 9,5 V?
Precharging not possible or battery damaged?
No voltage at external contacts?
Contacts of batteries corroded or damaged?
Check all cables, plugs and master fuses.
Battery-box lid or battery box damaged?
Locking belt damaged?
Guide pins or external contacts damaged?
66
> Danger of Short Circuit <
>Danger of Crushing<
Battery Box
+ Terminal
(red cable)
Removal of Battery Boxes
Locking Belt
Detail: External Contacts of the Batteries
Battery, outside
Battery inside
Guide Pins
Contacts
- Terminal
(blue cable)
R R e e m m e e d d y y
> Load batteries (see chapter 12.2).
> Load batteries (see chapter 12.2).
> Preload battery (see chapter 12.2)
> Replace battery.
> Replace master fuse (50A) or cable.
> Clean contacts, replace, if necessary.
> Replace if necessary.
> Replace if necessary.
> Replace locking belt.
> Replace, if necessary.
Swing up
Rear Light Bar
Battery Box
Guide Pins
Contacts
Battery