Lighting Module / Lighting And Adjustment Modules (Clam) Or Voltage Transformer - Invacare STORM Service Manual

17.7 Lighting Module / Lighting and Adjustment Module (CLAM) and Voltage Transformer
Preparation
• Remove splash protection. See chapter 11.7 in this respect.
• Remove cable binders at connection cables.
Removing the Modules
• Remove all plugs from the socket board of the module to be
replaced

NOTE:
Press down plug locks, as otherwise the plug will be
damaged.
• Loosen the two fastening screws of the module (SW 8 mm).
• Pull the module from the battery box retainer in downward
direction.
Installing the Modules
• Push the module into the battery box retainer from below
and fasten it by means of the two fastening screws.
• Insert the plugs into the module’s socket board.
The arrangement of the plugs can be seen from the connecting
plan.
• Attach new cable binders.
• Mount the splash protection.
Connecting Plan: Lighting Module and
102
Lighting / Adjustment Module (CLAM)
Hauptmodul
Power Module
Bedienelemente
Verstellmotoren / Licht
Remote
actuators / Light
Location of the cable binders
Remove Lighting and Lighting/Adjustment
Module (CLAM)
Fastening screw
M5 x 16 - SW 8
Detail: Fastening of the Module
Washer
Screw, M5 x 16 - SW 8
Cable
binders