Check And Repair Work On; Recaro Seat System; General; Headrest, Safety Belt - Invacare STORM Service Manual

10.0 Check and Repair Work on the Recaro Seating System

10.1 General

Chapter 10 and its sub-chapters are dedicated to the description of the special features of the Recaro seating
system. As to the disassembly / assembly of the legrests, the steps described in chapter 9 for the standard
seating system are applicable.
10.2 Headrest, Safety Belt and Push Handle
Recaro seat, assembled
2
1
1 Back module
4 Holder for push handle
7 Clamping lever M6x10

NOTE:
The Recaro seat can be designed as a complete seating module (model DS) with integrated control, or
or as model LX with detachable headrest and back module.
I I n n s s p p e e c c t t i i o o n n
• Headrest damaged?
• Safety belt damaged?
• Push handle damaged?
• Screwings loose?
Disassembly
• Pull headrest (2) upwards from
back module (1).
• Unscrew four screws located at the rear of the back module (1) and detach the safety belt (3).
• Release clamping lever (7) and detach push bar (5) with handle (6) from the holder (4).
• If necessary, pull handle (6) from the push bar (5).
• Unscrew four screws (8) with washers (9) completely and detach holder (4) from the back module (1).
Assembly
• Proceed with the assembly in reverse order.
2 Headrest
5 Push bar
8 4x Screws M6

NOTE:
As a rule, when removing the headrests, the clamps located under the
guide tubes must be removed first.
Recaro seat, disassembled
2
1
3 Safety belt
6 Handle
9 4x Washers
R R e e m m e e d d y y
> Replace headrest.
> Replace safety belt.
> Replace individual parts.
> Tighten screwings.
5
6
7
8 9
4
3
45