Joystick Box For Attendant - Invacare STORM Service Manual

17.2 Joystick Box for Attendant

1 Joystick box for attendant
2 BUS cable
3 Holder for RECARO seat
4 2x Clamping piece
5 4x Screw M6x35
6 4x Lock nut M6
7 Screw M6x16
8 Washer 6,4x12,5x1,6
9 Cap lock nut M6
10 Slide piece SL 22
11 2x Wing screw M6x10
12 Mounting angle
13 Holding plate
I I n n s s p p e e c c t t i i o o n n
• Check electrical functions!
• BUS plug defective?
• BUS cable damaged?
• Joystick tight or damaged?
• Screwings loose?
• Parts or holding device
completely defective?
Disassembly joystick box
• Detach BUS cable (2) from the joystick box (1).
• Loosen wing screws(11) and detach joystick box (1).
Assembly
• The assembly is performed in the reverse order.
Disassembly joystick box holder
• Detach joystick box (1) as described above.
• Loosen nut (9) and detach, together with washer (8), screw (7) and holding plate (13), from the mounting
(12) angle.
• Loosen 4 nuts (6) and detach, together with screws (7), mounting angle (12) and clamping pieces (4), from
the holder (3) or from the backrest, respectively.
• In the Recaro seat, loosen screw and detach holder (3) from the push handle.
• If necessary, remove slide piece (10).
Assembly
• The assembly is performed in the reverse order.
94
6
R R e e m m e e d d y y
See chapter 16.2.
> Replace BUS cable.
> Replace BUS cable.
> Replace joystick box.
> Tighten screws.
> Replace screws, replace
parts or holder, if required.
Joystick Box with Fixing Devices, disassembled
2
13
4
3
4 10

NOTE:
• In the Recaro seat, the joystick box
(1) with holder (3) is attached to the
push handle.
• In the remaining models, the joystick
box (1) with clamping piece(4) is
directly attached to the backrest.
1
7
5
12
11
8
9