Disassembly support plates
Remove rear battery box and jack up wheelchair, if appropriate.
If required, remove rear wheel. See chapter 11.3 in this respect.
Loosen screw (9) and nut (10) at the lower part of the support plate (3) completely.
Remove support castor (4) completely with bushings (12 and 13) and washers (11) from the support plates (3).
Loosen all screws (9) completely and remove together with nuts (10) and washers (11).
Detach support plates (3) from the chassis (1) and from the shock absorber (5).
Assembly
The assembly is performed in the reverse order.
Disassembly
s hock absorber
s
Remove rear battery box and jack up wheelchair, if appropriate.
If required, remove rear wheel. See chapter 11.3 in this respect.
Loosen nut (10) at the lower part of the shock absorber (5) completely and remove together with washer (11).
Loosen screw (6) at the upper part of the shock absorber completely and remove together with washer (7)
and bushing (8).
Detach shock absorber (5) from the chassis (1) and from the support plate (3).
Remove rear reflector with holder from the shock absorber (5).
Assembly
The assembly is performed in reverse order.
NOTE:
The shock absorbers are distinguished by versions 1500 Nm (up to 75 kgs users weight) and
2300 Nm (over 75 kgs users weight).
The rear reflectors are glued.
Disassembly rear wheel link
Lift seating system and lock, if necessary, or detach seating system entirely from the chassis (1).
Remove battery boxes and jack up wheelchair.
If necessary, loosen screws, washers and nuts completely and remove disengaging mechanism (15) from
the motor.
Remove drive unit. See chapter 11.6 in this respect.
Remove stopper (25).
Loosen nut (23) completely and remove with bushings (21 and 22).
Remove screw (20) with washer (26) and bushing (21).
Detach rear wheel link (18) from the chassis (1).
If necessary, remove bushings (19 and 24) from the link.
Assembly
The assembly is performed in reverse order.
60