16.2 Testing Joystick Boxes
NOTE:
Before inspecting the joystick boxes, check the
charging status of the batteries.
Then check status display for error codes.
I I n n s s p p e e c c t t i i o o n n
Status display flashing?
BUS plug defective?
BUS cable damaged?
Joystick tight or damaged?
Joystick box fastening
damaged?
Displays or key pad
defective?
Power supply to the
joystick box defective?
(For measuring see below.)
Checking Power Supply to Joystick Box
Pull BUS plug from the joystick box.
Measure voltage at the contacts indicated (see drawing).
The voltage must amount to at least 19 V.
CAUTION:
Do not bridge contacts. Danger of Short Circuit.
Malfunction
No voltage?
Voltage below 19 V?
NOTE:
The following inspections are to be performed at the attendants joystick box
(additional joystick box - switchable)
Check whether the control can be switched over by means of the flip switch.
Check whether the final speed can be pre-selected by means of the controller .
Check whether the wheelchair con be controlled via the joystick.
Check whether all other functions (lighting and adjustment functions) continue to be controllable via the
main joystick box.
NOTE:
When ordering a replacement joystick box, the part numbers and the number of the software version
must be indicated.
The software version number can be found on a sticker at the joystick box.
86
R R e e m m e e d d y y
> Check error codes.
See chapter 8.0.
> Replace BUS cable.
> Replace BUS cable.
> Replace joystick box.
> Renew wing screws, replace
holding device, if necessary.
> Replace joystick box.
> Check:
Battery charge, BUS plug,
BUS cable, main module
Cause
- BUS cable defective.
- BUS cable defective.
- Main module defective.
- Battery fully discharged.
Joystick Boxes
Standard
Table, centre
joystick box
control
Chin control
BUS Plug
Plug lock
min. 19 Volt
Remedy
> Test / replace BUS cable. (Chapter 18.0)
> Test / replace BUS cable. (Chapter 18.0)
> Test main module. (Chapter 16.3)
Test voltage supply to main module.
(Chapter 16.3)
> Test battery. (Chapter 12.2)
+
V