Invacare STORM Service Manual page 96

Disassembly joystick box
• Detach BUS cable (2) from the joystick box (1).
• Loosen screws (20) and detach joystick box (1) from its holder (3) or from its holding plate (4), respectively.
Assembly
• The assembly is performed in the reverse order.
Disassembly of the holder for the central control
• Detach joystick box (1) as described above.
• Disengage the clamping piece (9) at the carrier rod (8) and fold away the support arm (7) together with the
swivel arm (6).
• Loosen set screws (not shown) at upper part of the side pieces and remove carrier rod (8) and swivel arm (6)
completely from the wheelchair.
• Loosen nuts (13) and pull support arm (7) from the swivel arm (6).
• Detach holding plate (4) with washers (12) und pull the clamping pieces (11) from the swivel arm (6).
• Remove cap(14), loosen nut (15) and detach.
• Detach swivel arm (6) with washers (16) and bushes (17) from the guide rod (5).
• Loosen screws (10) and detach clamping piece (9) from the support arm (7).
• If required, detach slide pieces (18 and 19).
Assembly
• The assembly is performed in reverse order.
Disassembly of table plate and holder
• Detach joystick box (1) as described above.
• Loosen nuts (28) and remove together with washers (27) and screws (26).
• Detach table plate (24) with guide rod (32) from the receiving plate (23).
• Loosen nut (31)and remove together with screws (30).
• Separate guide rod (32) from the table plate (24).
• Separate holder (29) from the angle joints (33).
• Mark the position of the angle joints (33) and unscrew the joints from the guide rod (32).
• Loosen wing screw (25) and remove holder (3) from the guide rod (32).
• Loosen set screw (not shown) at the upper part of the side part and detach the guide rod (5) together
with the swivel arms (21 and 22) completely from the wheelchair.
• Loosen wing screw (25) and separte the swivel arms (21 and 22) from each other.
• Remove cap (14) at swivel arm (21), loosen nut (15) and detach.
• Detach swivel arm (21) with washers (16) and bushes (17) from the guide rod (5).
• Remove cap (14) on the swivel arm (22), loosen nut (15) and detach.
• Remove support plate (23) with washers (16) and bushes (17) from the swivel arm (22).
• If necessary, remove slide pieces (18 and 19).
Assembly
• The assembly is performed in reverse order.
96

NOTE:
• During the assembly make sure to insert the
bushes (17) and washers (16) correctly into
the swivel arm (6).

NOTE:
• While assembling make sure that the bushes
(17) with washers (16) are inserted correctly
into the swivel arm (21) and the support
plate (23), respectively.
• The angle joints (33) are to be mounted to
the guide rod (32) in such a way that allows the
table plate (24) to be screwed together with
the holder 29).
.